3Enter the fax number.

4Press Start. The FAX/MFC starts scanning the original and the screen displays the job number (#XX) of the fax, and how much memory is available. Then the FAX/MFC starts dialing. You can immediately repeat Steps 1 through 4 for the next fax.

Note Your FAX/MFC normally operates in Dual Access mode. However, you can override Dual Access by using Real Time Transmission.

Real Time Transmission

When you are sending a fax, the FAX/MFC will scan originals into memory before sending. Then, as soon as the phone line is free, the FAX/MFC will start dialing and sending the fax. If memory becomes full, the FAX/MFC will send the document in real time, even if REAL TIME TX is set to OFF.

Sometimes you may want to send an important document immediately, without waiting for memory transmission. You can set REAL TIME TX to ON.

1Place the original face down in the ADF.

2

For the FAX, press Function, 3, 9.

9.REAL TIME TX

 

For the MFC, press Function, 1, 3, 9.

 

 

3

To change the default setting, press or

REALTIME TX:ON?

 

 

to select ON (or OFF) and press Set. Go to Step 5— OR—For the next fax

transmission only, press or to select NEXT FAX ONLY and press Set.

4For the next fax only, press or to select ON (or OFF) and press Set.

5Press 1 if you want to select additional settings. The display returns to the SETUP SEND menu— OR—Press 2 if you are finished choosing settings and go to Step 6.

6Enter fax number and press Start.

Checking the Jobs Status

Check which jobs are still waiting in memory to be sent. (If no jobs are waiting, the screen displays NO JOB WAITING.) (See Canceling Jobs in Memory, page 6-4.)

1If the machine is idle,

For the FAX, press Function, 4. For the MFC, press Function, 1, 4.

OR

If the machine is busy, go to step 2.

2If you have multiple jobs waiting, use or to scroll through the list.

3Press Stop to exit.

6 - 3 S E T U P S E N D

Page 62
Image 62
Brother FAX 2600, MFC 4600 manual Real Time Transmission, Checking the Jobs Status, Real Time TX, Realtime TXON?