Brother FAX 2600, MFC 4600 Setting the Speaker Volume, Setting the Ring Volume, Memory Storage

Setting Volume Amplify

Please carefully read “Setting the Handset Volume” before you do the following steps:

1For the FAX, press Function, 1, 6. For the MFC, press Function, 1, 1, 6.

2Press or to select

VOL AMPLIFY:OFF? if none of the users

are hearing-impaired and go to Step 4

— OR—

If some or all of the users are hearing- impaired, select VOL AMPLIFY:ON?.

VOL AMPLIFY:OFF? SELECT <- -> & SET

3 If all the users are hearing-impaired, press	PERMANENT?
or to select PERMANENT? and
	SELECT <- -> & SET
press Set
— OR—

If only some of the users are hearing-

impaired, select TEMPORARY? and press Set.

4Press Stop to exit.

Setting the Speaker Volume

You can adjust the speaker volume of your FAX/MFC. First press Hook, then press or to select a speaker volume level.

When you press or to adjust the volume level, the display shows the setting you are choosing. Each key press changes the volume to the next level. The new setting will remain until you change it again.

Setting the Ring Volume

You can adjust the ring volume when your FAX/MFC is idle. You can turn the ring off or you can select a ring volume level.

As you press or to adjust the volume level, the FAX/MFC rings so you can hear the volume for the level shown on the display. Each key press changes the volume to the next setting. The new setting will remain until you change it again.

Memory Storage

In the event of a power failure, all settings in the INITIAL SETUP, SETUP RECEIVE, SET AUTO DIAL, and REMOTE FAX OPT functions plus the COVERPG SETUP and COVERPG MSG (from SETUP SEND) functions are stored permanently. You may have to reset the date and time.

4 - 5 I N I T I A L S E T U P