Brother MFC 7050C Setting the Speaker Volume, Setting Volume Amplify, Vol Amplifyoff?, Permanent?

Setting Volume Amplify

Please carefully read “Choosing the Handset Volume,” page 5-5 before you do the following steps:

1Press Function , 1 , 1 , 6 .

VOL AMPLIFY:OFF?

SELECT <- -> & SET

2 Press or to select VOL AMPLIFY:OFF? if none of the users are hearing-impaired and go to Step 4— OR—

if some or all of the users are hearing-impaired, select VOL AMPLIFY:ON?.

PERMANENT?

SELECT <- -> & SET

3

4

5

Press or to select PERMANENT? if all the users are hearing-impaired— OR—select TEMPORARY? if only some of the users are hearing-impaired.

Press Set .

Press Stop to exit.

Setting the Speaker Volume

You can adjust the volume of the one-way speaker when your MFC is on Hook . You can turn the speaker off or you can select a speaker volume level. The default setting is the lowest volume.

■Press L or H to adjust the volume level. The display shows the setting you are choosing. Each key press changes the volume to the next setting. The new setting will remain until you change it again.

You can adjust the speaker volume while you are listening to your OGM (Outgoing Message) and ICMs (incoming messages).

If you turn the Incoming Recording Monitor to OFF

( Function , 1 , 7 , 5 ), the Speaker for screening calls will be disabled and you will not be able to hear callers leaving messages. The volume for other operations can still be controlled using L and H .

5-6 I N I T I A L S E T U P