5-5
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter5 IP Commands
distribution-type
distribution-type
To configure the type of load distribution that your Ethernet gateway uses to communicate wit h a Li nk
Aggregation-aware switch, enter the
distribution-type
command in Trunk Interface Configuration
submode.
distribution-type
{
dist-ip
|
dst-mac
|
src-dst-ip
|
src-dst-mac
|
src-ip
|
src-mac
|
round-robin
}
Syntax Description
Defaults The distribution-type defaults to src-mac.
Command Modes Trunk Interface Configuration (config-if-trunk) submode.
Usage Guidelines Platform Availability:
Cisco SFS 3001, Cisco SFS 3012
Privilege Level:
Ethernet read-write user.
You must configure a distribution type to bridge to a load aggregation-aware Ethernet switch. Contact
your administrator to discover if a switch is load aggregation-aware.
dst-ip Bases the load distribution on the destination IP address of the incoming
packet. Packets to the same destination travel on the same port, but packets
to different destinations travel on different ports in the channel.
dst-mac Bases the load distribution on the destination host MAC address of the
incoming packet. Packets to the same destination travel on the same port, but
packets to different destinations travel on different ports in the channel.
src-dst-ip Bases load distribution on the IP address of the source logic gate (XOR)
destination.
src-dst-mac Bases load distribution on the MAC address of the source logic gate (XOR)
destination.
src-ip Bases the load distribution on the source IP address. Packets from t h e s ame
source travel on the same port, but packets from different sources travel on
different ports in the channel.
src-mac Bases load distribution on the source MAC address of the incoming
packet.Packets from different hosts use different ports in the channel, but
packets from the same host use the same port in the channel.
round-robin Bases the load distribution on a circular pattern to create an evenly
distributed load.