5-7
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter5 IP Commands
half-duplex
half-duplex
To configure an Ethernet connection in half duplex mode, enter the
half-duplex
command in Ethernet
Interface Configuration submode. To undo this configuration, use the
no
form of this command.
half-duplex
no half-duplex
Syntax Description This command has no arguments or keywords.
Defaults Your Server Switch runs in full duplex mode by default.
Command Modes Ethernet Interface Configuration (config-if-ether) submode.
Usage Guidelines Platform Availability:
Cisco SFS 3001, Cisco SFS 3012
Privilege Level:
Ethernet read-write user.
If you disable auto-negotiation, set speed and duplex mode with the
half-duplex
command and
speed
command.
You cannot manually configure half duplex mode while auto-negotiation runs on your Server Switch or
while the connection speed exceeds 1000 Mbps.
Note The 6-port Ethernet gateway does not support half duplex transmission or 10 Mbps speed.
Examples The example below configures half duplex mode for ports 1 - 4 on slot 4:
SFS-7000P(config-if-ether-4/1-4/4)# half-duplex
Related Commands auto-negotiate
show interface ethernet
speed