6-119
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter6 Show Commands
show ib sm port
Examples The following example displays the details of the ports that the specified subnet manager manages:
SFS-7000P> show ib sm port subnet-prefix fe:80:00:00:00:00:00:00
================================================================================
Subnet Management Ports
================================================================================
subnet-prefix : fe:80:00:00:00:00:00:00
node-guid : 00:02:c9:01:07:e4:41:d0
if-index : 1
mkey : 00:00:00:00:00:00:00:00
gid-prefix : fe:80:00:00:00:00:00:00
lid : 2
master-sm-lid : 1
cap-mask : 00:10:02:48
diag-code : 10:26
mkey-lease-period : 15
link-width-enabled : 3
link-width-supported : 3
link-width-active : 2
link-speed-supported : 1
qkey-violation Number of subnet management packets that have been received on this port
with invalid Q_Keys since initial power up or the last reset. See section
10.2.4, Q Keys, InfiniBand Architecture®, Vol. 1, Release 1.1, for more
information.
guid-cap Number of GUID entries allowed for this port in the port table. Any entries
that exceed this value are ignored on write and read back as zero. See
section 14.2.5.5, GUIDCap, InfiniBand Architecture®, Vol. 1, Release 1.1,
for more information.
subnet-timeout Maximum propagation delay allowed for this port to reach any other port
in the subnet. This value also affects the maximum rate at with traps can be
sent from this port. Switch configuration affects delay. Requestors may use
this parameter to determine the interval to wait for a response to a request.
Duration matches (4.096 ms * 2^SubnetTimeout).
resp-time Maximum time allowed between the port reception of a subnet management
packet and the transmission of the associated response. See section
13.4.6.2, Timers and Timeouts, InfiniBand Architecture®, Vol. 1, Release
1.1, for more information.
local-phy-error Threshold at which ICRC, VCRC, FCCRC, and all physical errors result in
an entry into the BAD PACKET or BAD PACKET DISCARD states of the
local packet receiver. See section 7.12.2, Error Recovery Procedures,
InfiniBand Architecture®, Vol. 1, Release 1.1, for more information.
local-overrun-error Threshold at which the count of buffer overruns, across consecutive
flow-control update periods, result in an overrun error. A possible cause of
such errors is when an earlier packet has physical errors and the buffers are
not immediately reclaimed.
Table6-41 show ib sm port Command Field Descriptions (continued)
Field Description