6-43
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter6 Show Commands
show diagnostic interface fc
Examples The following example displays the completed and ongoi ng dia gnos tic te sts o n a ll Eth erne t po rts:
SFS-7000P# show diagnostic interface ethernet all
================================================================================
Diagnostic Tests For Ethernet Interfaces
================================================================================
test : external-loopback
port : 6/3
validation : enabled
data-size : 0
data-pattern : 00:00:00:00
iterations : 0
action : stop
result : none
percentage-completed : 0
result-string : External Loopback Test In-progress, Current report : Passed=0,
Failed=0, Total=0
The following example displays the diagnostic tests available:
SFS-7000P(config)# diagnostic interface fc 6/1
SFS-7000P(config-diag-if-fc-6/1)# ?
> diagnostic Configuration Commands:
> data-pattern - Configure a data pattern to use in traffic test
> cases
> data-size - Configure size (in octects) of payload data
> exit - Exit current mode
> help - Show command help
> history - Show command history
> iterations - Configure number of iterations the test case
> should be run
> no - Disable a configuration or set default
> source-id - Specify source identifier for use with FC Echo test
> start - Initiate a test
> stop - Stop a test
> target-id - Specify target identifier for use with FC Echo test
> test - Configure the test case to run
> validate - Enable data validation to be performed on
> received packets
> Topspin-360(config-diag-if-fc-6/1)# test ?
> echo - Configure Echo test
> ext-loopback - Configure External-Loopback test
> int-loopback - Configure Internal-Loopback test
Related Commands show diagnostic