7-226
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter7 Diagnostic Commands
test
test
Specify a diagnostic test to run with the test command in appropriate Diagnostic Co nfiguration submode.
test {echo | int-loopback | ext-loopback | led | self-test}
Note The SFS 7000 does not support external loopback tests for InfiniBand interfaces. Table 7-8 describes
the different tests that you can run and the interfaces or card s on w hic h you can run th em.
Syntax Description
Defaults This command has no default settings.
Command Modes Fibre Channel Interface Diagnostic Configuration (config-diag-if-fc) submode, Ethernet Interface
Diagnostic Configuration (config-diag-if-en) submode, InfiniBand Interface Diagnostic Configuration
Usage Guidelines Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Read-write user.
Examples The following example specifies a LED test to run on card 11 when the start command executes:
SFS-7000P (config-diag-card-11)# test LED
Related Commands diagnostic
show interface ethernet
show interface fc
show interface gateway
start
stop
echo Echo test (Fibre Channel gateway only).
int-loopback Internal loopback test (unsupported).
ext-loopback External loopback test (Fibre Channel gateway only).
led LED test.
self-test Self test.
ext-cable External cable test (unsupported).