6-41
Cisco SFS 7000 Series Product Family Command Reference Guide
OL-9163-02
Chapter6 Show Commands
show diagnostic interface ethernet
Examples The following example displays the completed and ongo i ng di agnos tic te sts o n p ort 1 o f Ethe rn et gateway 9:
SFS-7000P# show diagnostic interface ethernet 9/1
================================================================================
Diagnostic Tests For Ethernet Interfaces
================================================================================
test : led
port : 9/1
validation : enabled
data-size : 0
data-pattern : 00:00:00:00
iterations : 0
action : stop
result : none
percentage-completed : 0
result-string : Unknown Test Unknown status, Current report : Passed=0,
Failed=0, Total=0
The following example displays the diagnostic tests available:
SFS-7000P# (config)# diagnostic interface ethernet 2/1
SFS-7000P# (config-diag-if-ether-2/1)# ?
>diagnostic Configuration Commands:
data-pattern - Configure a data pattern to use in traffic test
cases
data-size - Configure size (in octects) of payload data
exit - Exit current mode
help - Show command help
history - Show command history
iterations - Configure number of iterations the test case
should be run
no - Disable a configuration or set default
start - Initiate a test
stop - Stop a test
test - Configure the test case to run
validate - Enable data validation to be performed on
received packets
SFS-7000P# (config-diag-if-ether-2/1)# test ?
ext-loopback - Configure External-Loopback test
led - Configure LED test
Related Commands show diagnostic