Cleveland Range inverter manual Appendix A - Functions Based On The Use, Related Parameter Code

APPENDIX A - FUNCTIONS BASED ON THE USE

Set the function properly according to the load and operating conditions. The application and the related functions are listed at the following table.

Use			Related Parameter Code
Accel/Decel time, pattern adjustment			DRV-01 [Acceleration Time], DRV-02 [Deceleration Time],
			FU1-05 [Acceleration Pattern], FU1-06 [Deceleration Pattern]
Reverse rotation prevention			FU1-03 [Forward, Reverse Prevention]
Minimum time Accel/Decel			FU1-05 [Acceleration Pattern], FU1-06 [Deceleration Pattern]
Accel/Decel at continuous rating range			FU1-05 [Acceleration Pattern], FU1-06 [Deceleration Pattern]
Braking operation adjustment			FU1-07 [Stop Method], FU1-08~11 [DC Braking],
			FU1-12~13 [DC braking at Start]
			FU1-20 [Maximum Frequency],
Operations for frequencies over 50 Hz			FU1-25 [Frequency Upper Limit],
			I/O-05 [Frequency Corresponding to Max. Voltage of V1],
			I/O-10 [Frequency Corresponding to Max. Current of I]
Selecting an appropriate output			FU1-20 [Maximum Frequency],
characteristics for the load			FU1-21 [Base Frequency]
			FU1-22 [Starting Frequency],
Motor output torque adjustment			FU1-26~28 [Torque Boost],
			FU1-59~60 [Stall Prevention],
			FU2-30 [Rated Motor]
Output frequency limit			FU1-23~25 [Frequency Upper/Lower Limit],
			I/O-01~10 [Analog Frequency Setting]
Motor Overheat protection			FU1-50~53 [Electronic Thermal], FU2-30 [Rated Motor]
			I/O-12~14 [Define the Multi Function Input Terminals],
Multi step operation			I/O-20~27 [Jog, Multi Step Frequency],
			FU1-23~25 [Frequency Upper/Lower Limit]
Jog Operation			I/O-20 [Jog Frequency]
Frequency Jump Operation		FU2-10~16 [Frequency Jump]
Timing the electronic brake operation			I/O-42~43 [Frequency Detection Level],
			I/O-44 [Multi Function Output]
Displaying the rotating speed			DRV-04 [Motor Speed],
			FU2-74 [Motor RPM Display Gain]
Function alteration prevention			FU2-94 [Parameter Lock]
Energy Saving			FU1-39 [Energy Saving]
Auto restart operation after alarm stop			FU2-27~28 [Auto Retry]
2nd motor operation			FU2-81~90 [2nd Function]
PID feedback operation			FU2-50~54 [PID Operation]
Frequency reference signal and output			I/O-01~10 [Analog Frequency Setting]
adjusting
Define the multi function input terminals			I/O-12~14 [Define the Multi Function Input Terminals]
Define the multi function output terminals			I/O-44 [Multi Function Output Setting]
Commercial line <-> inverter switchover			I/O-12~14 [Define the Multi Function Input Terminals],
operation			I/O-44 [Multi function Output Setting]
Frequency meter calibration			I/O-40~41 [FM Output]
			I/O-46 [Inverter No.],
Operate by communicating with a computer			I/O-47 [communication Speed],
			I/O-48~49 [Loss of Reference]
	104