Cleveland Range inverter manual Function Group 2 FU2, Parameter List

Chapter 3 - Parameter List

3.3 Function Group 2 [FU2]

Code	Description	Keypad	Setting Range	Units	Factory	Adj.	Page
						During
		Display			Default
						Run
FU2-00	Jump to Desired Code #	H 0	1 to 99	1	30	Yes	50
FU2-01	Previous Fault History 1	H 1
FU2-02	Previous Fault History 2	H 2			None
FU2-03	Previous Fault History 3	H 3		-		-
					n0n
FU2-04	Previous Fault History 4	H 4					50
FU2-05	Previous Fault History 5	H 5
FU2-06	Erase Fault History	H 6	0 (No)	-	0 (No)	Yes
			1 (Yes)
FU2-07	Dwell Frequency	H 7	0 to FU1-20	0.01	5.00 [Hz]	No	50
FU2-08	Dwell Time	H 8	0 to 10 [sec]	0.1	0.0 [sec]	No
FU2-10	Frequency Jump Selection	H 10	0 (No)	-	0 (No)	No
			1 (Yes)
FU2-1112	Jump Frequency 1 Low	H 11	0.00 to (FU2-12)	0.01	0.00 [Hz]	No
FU2-12	Jump Frequency 1 High	H 12	(FU2-11) to (FU1-20)	0.01	0.00 [Hz]	No	51
FU2-13	Jump Frequency 2 Low	H 13	0.00 to (FU2-14)	0.01	0.00 [Hz]	No
FU2-14	Jump Frequency 2 High	H 14	(FU2-13) to (FU1-20)	0.01	0.00 [Hz]	No
FU2-15	Jump Frequency 3 Low	H 15	0.00 to (FU2-16)	0.01	0.00 [Hz]	No
FU2-16	Jump Frequency 3 High	H 16	(FU2-15) to (FU1-20)	0.01	0.00 [Hz]	No
			00 – 11 (bit set)
FU2-19		H 19	Bit 0: Output Phase
	Input/Output Phase Loss Protection		Loss Protection	-	00	Yes	51
			Bit 1: Input Phase
			Loss Protection
FU2-20	Power ON Start Selection	H 20	0 (No)	-	0 (No)	Yes	52
			1 (Yes)
FU2-21	Restart after Fault Reset	H 21	0 (No)	-	0 (No)	Yes	52
			1 (Yes)
			0000 – 1111 (bit set)
			Bit 0: During Accel.
FU2-22		H 22	Bit 1: After Fault reset
	Speed Search Selection		Bit 2: After Instant	-	0000	No	53
			Power Failure restart
			Bit 3: When FU2-20 is
			set to 1 (Yes).
FU2-23	Current Limit Level During Speed	H 23	80 to 250 [%]	1	180 [%]	Yes	53
	Search

12Code FU2-11 through FU2-16 appears only when FU2-10 is set to ‘Yes’.

27