Cleveland Range inverter manual Operation, Adjusting Function and I/O Group Data

Chapter 2 - Operation

To Monitor Fault Type when a Fault Occurs (Data cannot be set)

SET

FWD FUNC SET

FWD SET

FWD

RUN

REV RUN

REV RUN

REV

Frequency

SET RUN

SET

FWD

REV

FWD

Trip Current

FUNC

RUN

REV

During Accel

The fault type is displayed on the DRV group when a fault occurs. Frequency, current and operating status (accelerating, decelerating, in constant speeds) may be monitored by using the UP, DOWN arrow keys.

(Ex: Fault occurred when the inverter was accelerating at 40.28 Hz, 20.5A) 4 LED is blinking in this situation.

Fault status can be removed by using the STOP/RESET Key, and the LED turns OFF. (The inverter must be turned OFF and turned ON again to remove HW fault status.)

Adjusting Function and I/O Group Data

Example) Changing the F5 data to 1:

SET

RUN

SET

RUN

SET

RUN

FWD FUNC SET

REV RUN

FUNC

FWD

REV

FWD FUNC SET

REV RUN

FWD SET

REV RUN

FUNC

FWD SET

REV RUN

FWD

REV

FWD

REV

18