Compaq 386 manual Power Cable Connections for Drive Positions B and C

Maintenance and Service Guide 7-37

2.Locate and disconnect the signal cable and the power cable from the back of the mass storage device in drive position B or C (Figure 7-40).

3.Remove the retaining screws on the side of the drive housing assembly.

4.Slide the mass storage device out of the drive position (Figure 7-41).

Figure 7-40.Disconnecting Cables from Mass Storage Device B or C.

To replace a half-height storage device in drive position B or C, reverse steps 1 through 4, following the power cable connection guidelines in Table 7-3.

Table 7-3. Power Cable Connections for Drive Positions B and C

Drive Position	System Board Connector
B	J111
C	J109

Figure 7-41.Removing a Mass Storage Device from Position B and C.

Addendum 108431-001 (11-88) to Manual No. 108033-003