Compaq 386 manual Configuration Switch Bank SW3

Maintenance and Service Guide 8-27

Configuration Switch Bank SW3

If the SW3 switches are present, they are reserved and should be set to the OFF position.

Jumper P1 Settings for the COMPAQ Enhanced Color Graphics Board

The setting for Jumper P1 is determined by the monitor used with the COMPAQ Enhanced Color Graphics Board (Figures 8-13 and 8-14).

To reset the jumper, remove the jumper from its current pins and press it into place on the correct pins.

Jumper JP3 Setting for the COMPAQ Enhanced Color Graphics Board

Pin 1-2 is the standard factory setting. Do not change this setting.

Figure 8-13.Setting for a COMPAQ Color or Compatible Enhanced Color Monitor.

Figure 8-14.Setting for an RGBI Color Monitor or a COMPAQ Dual-Mode Monitor.