Compaq 386 manual Locating and Removing Terminating Resistor

Maintenance and Service Guide 7-53

To remove the terminating resistor, complete the following steps:

1.Locate the terminating resistor on the fixed disk drive.

NOTE: Terminating resistors are located in different positions depending on the manufacturer.

2.Remove the terminating resistor on the fixed disk drive using needle-nosed pliers (Figure 7-53).

Figure 7-53.Locating and Removing the

Terminating Resistor.

To install the fixed disk drive in the expansion unit, reverse steps 1 through 5.

Addendum 108431-001 (11-88) to Manual No. 108033-003