7-48 Chapter 7, Removal and Replacement Procedures
CAUTION
More pressure is needed to press the copro- cessor into the socket than is required for installing memory chips. BE SURE the pres- sure exerted is firm enough to seat the coprocessor and is applied evenly over the surface of the coprocessor.
3.Press the coprocessor into the coprocessor socket.
NOTE: If you think the coprocessor is not seated properly, use the coproces- sor removal tool to remove the coprocessor, and try again to install it.
4.Verify DIP switch settings.
5.Complete the replacement procedures in the following sections:
a. 7.16 SYSTEM BOARD. Be sure to tighten the mounting screws because they provide proper grounding for the system.
NOTE: When you reconnect the power cables, refer to the configuration label on the drive housing assembly for the location of the connectors.
b. 7.14 SPEAKER ASSEMBLY AND SECURITY LOCK SWITCH.
c. 7.10 EXPANSION BOARD(S).
d. 7.6 SYSTEM UNIT COVER AND INTERNAL CONFIGURATION
e. 7.5 PREPARING THE SYSTEM UNIT FOR THE INTERNAL REMOVAL AND REPLACEMENT PROCEDURES
