Compaq 386 manual Advanced Diagnostics Error Codes

5-18 Chapter 5, Error Messages and Codes

Table 5-2. Advanced Diagnostics Error Codes Continued

Error		Recommended
Code	Description	Action
1101-14	Serial Port Test, DRIVER/RECEIVER	The following steps apply to error codes 1101-xx
	data failure.	through 1109-xx.
1109-01	Clock register initialization failure.	1. Check the switch settings and jumper positions on
		the multipurpose fixed disk controller board (see
1109-02	Clock register rollover failure.
		Chapter 8).
1109-03	Clock reset failure.
		2. Replace the multipurpose fixed disk drive controller
1109-04	Input line or clock failure.	board and retest.
		3. Replace the system board and retest.
1109-05	Address line fault.
1109-06	Data line fault.
Modem Communications Test
1201-xx	Modem Internal Loopback Test	The following steps apply to error codes 1201-xx
		through 1210-xx:
01	UART DLAB bit failure.
		1. Refer to the modem documentation for correct setup
02	Line input or UART failure.
		procedures.
03	Address line fault.
		2. Check the modem line.
04	Data line fault.	3. Replace the modem and retest.

05UART control signal failure.

06UART THRE bit failure.

07UART DATA READY bit failure.

08UART TX/RX buffer failure.

09INTERRUPT circuit failure

10COM1 set to invalid interrupt.

11COM2 set to invalid interrupt.

12DRIVE/RECEIVER control signal failure.

Continued...

Addendum 108431-001 (11-88) to Manual No. 108033-003