DI-1162 Remote Access Router

to implement – we have described some of the basic functions and procedures below.

Dial-In User Connections

Dial-in users are defined as a single user on a computer, such as a person working at home, who dials into the office to use network resources. In almost all cases, a Dial-In User Profile needs to be set up for each user who will dial in to the router so the router can tailor the connection for each user. Once this is done, the remote user will be able to use network resources as if he were connected locally. When the user dials into the DI-1162, the call comes into the WAN port and after answering the phone, the DI-1162:

1.Identifies the Username and Password using the authentication protocol defined in the Interface Configuration, WAN submenu. The dial-in user is not prompted for this information, but must enter it into his dialing software before dialing.

2.Checks the Username and Password against those defined in the Dial-In User Profiles and Remote Network Profiles.

3.Assuming a matching Dial-In User Profile is found, the router may configure the IP address of the remote station (as defined in the Dial-In User Profile).

4.Configures a dial-in Interface (a virtual circuit) to handle the connection.

5.Establishes the connection.

6.In the case where the Dial-In User does not need to supply a Username and Password (Auth Type is set to None in the Interface Configuration submenu) the remote computer must have its own IP address.

Remote Network Connections

Remote networks are defined as other networks (LANs) that have WAN connections using a router, Internet server, network modem or similar device (in this document however, we will assume the remote

48

Configuration and Management

Page 58
Image 58
D-Link DI-1162 manual Dial-In User Connections