D-Link DI-1162 manual Wan

DI-1162 Remote Access Router

Range – is the number of IP Addresses that can be assigned. In the window shown above, dial-in users will be assigned the IP Addresses 170.100.200.1 or 170.100.200.2 (only two are necessary since the router used in the examples has only two WAN ports).

WAN 1

This submenu contains a number of settings (shown below) which allow you to configure the router to dial out.

The parameters are described below:

•Idle Time – this is the elapsed time (in seconds), of inactivity, that will trigger the router to disconnect this interface.

•Dial-Out Retry Time – this is the time (in seconds) the router will wait before the next dial attempt.

•Dial-Out Retry Count – this is the specified maximum number of dial attempts the router will make when trying to establish a connection on this interface.

•Dial on Demand – this disables or enables dial on demand on this interface. If enabled, when a packet arrives at this port, the router

Configuration and Management 53