DI-1162 Remote Access Router
3.Assign an IP address to the WAN port in the Network Configuration
♦Still in Network Configuration, IP Configuration submenu from Step 2 above, choose IP Stack Configuration, WAN 1.
♦Enter a valid IP address for the WAN in the first item. You may also enter a Netmask if you wish. For more information about IP Addresses and Subnet masks, please refer to Appendix C – IP Concepts.
♦Other items in this screen may also need to be configured such as the State, Routing and Multicast settings. Please refer to the appropriate section in the Configuration and Management chapter of this User Guide for detailed explanations concerning the nature and use of these items.
♦Position the cursor on the Save option at the bottom of the screen and press <Enter> to save the new setting.
♦Choose Exit in the
Configuring for Dial-in, Dial-out or Leased Line
At this point, you need to decide if the WAN port will be used for dialing in, dialing out, both or a leased line connection. The settings you make in next few steps depend on how you wish to use the WAN port. Remember, only one WAN port should be setup to connect to the Internet.
4.Configure the Dial settings in the Advanced Functions submenu.
♦Choose Advanced Functions, Remote Access Configuration, Dial Configuration.
Installation | 21 |
