DCS 500 manual Uploading and Downloading of Parameters UPLOAD/DOWNLOAD, IV A 3

Chapter 3 - Handling of Control Panel CDP 31x

3.9 Uploading and Downloading of Parameters (UPLOAD/DOWNLOAD)

CAUTION! The drive must be in standstill condition with given STOP command (controllers blocked, power section disconnected from the network) when UPLOAD/ DOWNLOAD function is selected.

		DCS 500	FPROM = FLASH-PROM
	Parameter 11202:		RAM = Random Access Memory
Control	1 = SAVE MOT1 SET
Panel	2 = SAVE MOT2 SET	FPROM D35
		FPROM D33&34	FACTORY-	Parameter 11202:
				4 =SELECT MOT1 SET
			SET VALUE
FPROM	UPLOAD			5 =SELECT MOT2 SET
		RAM
	DOWNLOAD

If one or both of these functions have been performed additional ac- tions may be needed. For example BACKUPSTOREMODE should be selected for saving the values to the backup memory, if a DOWNLOAD had taken place.

UPLOAD will copy all parameters and connections, which are dif- ferent to default, from the RAM memory of the drive to the FPROM memory of the Control Panel CDP 31x.

Before a DOWNLOAD is started the factory-set values (default val- ues) should be available within the drive´sRAM memory. Factory-set values are always available in control board memory and they can be called by means of BACKUPSTOREMODE pa- rameter 11202 [FACTORY_SET_VALUE] or by means of S2 switch on the control board SDCS-CON-x.

The DOWNLOAD will copy all values stored in the FPROM memory of the CDP 31x to the RAM memory of the drive. Downloaded parameters should be saved to the FPROM memory of the control board SDCS-CON-x. See chapter 3.5"Saving of Parameters to backup memory" .

Note: For reasons of safety the DOWNLOAD function will only operate if „LOCAL mode“ of the Control Panel CDP 31x is selected!

IV A 3 - 10 DCS 500B / DCP 500B Operating Instructions

3ADW000055R0401_DCS500B_Operating Instruction_e_d