DCS 500 Contents, Iv A Operating Instructions, Handling of Control Panel CDP, Safety Instructions

Contents

IV A OPERATING INSTRUCTIONS

Safety Instructions
Chapter 1 - Introduction
How to use this manual		1-1
Contents of this manual		1-1
Target group		1-1
Associated publications		1-1
Incoming inspection		1-2
Storage and transport		1-2
Rating plate		1-2
Chapter 2 - Start-Up Instructions
General notes		2-1
2.1	Preparatory work	2-5
2.2	Scaling intra-unit signals	2-6
2.3	Presetting the field supply unit	2-8
2.4	Adjusting the current controller	2-10
2.5	Speed feedback balancing	2-12
2.6	Balancing the field supply unit and the e.m.f. controller	2-14
2.7	Balancing the speed controller, plus fine-balancing the e.m.f. and the current contr	2-20
2.8	Matching the thyristor power converter unit to the system conditions concerned	2-21
2.9	Presetting the 3-phase field supply unit DCF 50xB	2-22
Chapter 3 - Handling of Control Panel CDP 31x
3.1	Overview	3-1
	Panel Link	3-1
	Mounting the Panel	3-1
3.2	Start Mode	3-2
3.3	Panel Functions	3-3
	Actual Signal Display Mode	3-3
	Parameter Mode	3-4
	Function Mode	3-4
	Drive Mode	3-5
3.4	Pin/Parameter Selecting and Changing of Value	3-5
3.5	Saving of the Parameters to backup memory	3-7
3.6 FAULT RESETTING (RESET)		3-8
3.7 EMERGENCY STOP RESETTING (RESET)		3-8
3.8	Fault History Display	3-9
3.9	Uploading and Downloading of Parameters (UPLOAD/DOWNLOAD)	3-10
3.10 Setting of the Display Contrast		3-12
3.11 Full Name of output pins		3-12
3.12 Selecting output pins		3-13
3.13 Drive Mode		3-14
3.14 Running the Drive		3-15
	Operational Command Keys	3-15
iv	DCS 500B / DCP 500B Operating Instructions

3ADW000055R0401_DCS500B_Operating Instruction_e_d