1. Ensure that you read the Safety instructions.
2. Turn off the system, including any attached peripherals.
3. Disconnect the system from the electrical outlet and disconnect the peripherals.
4. Remove the system from the rack.
5. Keep the Phillips #1 screwdriver ready.
Steps
1. Remove the screws securing the system top cover to the chassis.
2. Slide the system top cover toward the back of the system.
3. Hold the cover on both sides, and lift the cover away from the system.
Figure 7. Removing and installing the system top cover (back)
1. guide slot on the system cover 2. system top cover (back)
3. screw (2) 4. tab on the chassis (6)
Installing the system top cover (back)Prerequisites
1. Ensure that you read the Safety instructions.
2. Ensure that all internal cables are connected and routed correctly.
3. Keep the Phillips #1 screwdriver ready.
NOTE: Closing the system cover with incorrect cable routing can damage the cables.
Steps
1. Align the slots of the system top cover with the tabs on the chassis.
2. Align the guide pin on the back of the chassis with the guide slot on the back of the cover.
3. Slide the cover toward the front of the chassis until the guide pin on the back of the chassis locks
into the guide slot on the back of the cover.
4. Secure the system top cover to the chassis by using the screws.
42