Figure 16. Removing and Installing a Processor/DIMM Blank

 

1.

processor socket

2.

processor/DIMM blank

3.

tabs (4)

4.

heat sink retention screws (4)

Installing A Processor/DIMM Blank

1.Remove the blade from the enclosure.

2.Open the blade.

3.If installed, remove the processor and heat sink.

4.Position the processor/DIMM blank on the system board with the holes on the tabs of the processor/ DIMM blank secured to the heat sink retention screws on the system board.

5.Install the cooling shroud.

6.Close the blade.

7.Install the blade in the enclosure.

44

Page 44
Image 44
Dell M820 owner manual Removing and Installing a Processor/DIMM Blank