Dynalink RTA1046VW user manual Quick Start, Connect to Internet, Quick Setup

Chapter 4: Web Configuration

Quick Start

The pages under the Quick Start menu provide user a quick way to set up the IAD. If you do not know much about the router, you can use the Quick Start pages to adjust basic settings to activate your IAD.

Connect to Internet

This is a quick way to connect to the Internet by using PPPoE interface, please click Connect to Internet to open the web page.

Enter the user name and password (that you get from the ISP) for your Wireless IAD and click Connect.

The system will connect automatically, and then you can access the Internet.

Quick Setup

The quick setup wizard will guide you to configure this IAD through some specific steps. Yet different connection interface will lead to different setting pages. Refer to the following pages for detailed information.

Auto Scan Internet Connection (PVC):

If there is no any PVC configured in your IAD, you can check this item. Otherwise, please uncheck this box.

VPI (Virtual Path Identifier): Identifies the virtual path between endpoints in an ATM network. The valid range is from 0 to 255. To enter the setting, please refer to the setting that the ISP offered.

VCI (Virtual Channel Identifier): Identifies the virtual channel endpoints in an ATM network. The valid range is from 32 to 65535 (1 to 31 is reserved for well-known protocols). To enter the setting, please refer to the setting that the ISP gave you.

After entering the VPI/VCI value, please click Next for the following step.

67