Dynalink RTA1046VW user manual Physical Outlook, Front Panel, LED Indicators

Chapter 1: Overview

Chapter 1: Overview

This chapter provides you the description for the LEDs and connectors on the front and rear surface of the IAD. Before you use/install this wireless IAD, please take a look at the information first.

Physical Outlook

Front Panel

The following illustration displays the front panel of the Wireless IAD:

LED Indicators

The Wireless IAD is equipped with several LEDs on the front panel as described in the table below:

Function	Color	Definition
	Off	Power is off.
	Solid Green	Power is on and the device operates normally.
	Solid Red	Power on self-test in progress
Power		The device enters the console mode of the boot
		loader.
		Power on self-test failure if the led always stays solid
		red.
	Flash Red	Firmware upgrades in progress
	Off	No DSL signal is detected.
DSL	Slow Flash Green	DSL line is handshaking in progress
	Fast Flash Green	DSL line is training in progress
	Solid Green	DSL line connection is up.
PPP	Off	No PPPoA or PPPoE connection
	Solid Green	At least one PPPoA or PPPoE connection is up. The
		users can access the Internet now.
Ethernet	Off	No Ethernet signal is detected.
	Flash Green	User data is going through Ethernet port
	Solid Green	Ethernet interface is ready to work.
USB	Off	No USB signal is detected.
	Flash Green	User data is going through USB port
	Solid Green	USB interface is ready to work.
WLAN	Off	No radio signal is detected.
	Flash Green	User data is going through WLAN port
	Solid Green	WLAN interface is ready to work.
Phone 1 or 2	Off	The phone is on-hook or in PSTN mode.
	Flash Green	There is one incoming VoIP phone call.
	Solid Green	VoIP phone call is in use.
	Off	Voice over IP service is not ready. The users can
VoIP Ready		make PSTN phone calls only.
	Solid Green	Voice over IP service is ready.

1