Gilson 402 manual Enter, Next, Reag, Dilute Serially, Operation - Advanced Use, Software

Operation - Advanced Use 5

Press Next, then key in the sample volume, press

ENTER.

Depending on the mode, you see one of three screens after pressing

Next.

Key in the value, press ENTER.

Optionally, for any mode, you can display the variables calculated

by the software by pressing Data.

Optionally, you can modify the flow rates; press Flow,

For any mode, key in a value for Asp flow, press ENTER, press Next, key in a value for Disp flow, press ENTER.

Optionally, for any mode, you can supply up to 12 reagents, press Reag, key in number of reagents, press ENTER.

Press Next, then for each reagent, key in volume press ENTER.

After the data are entered the Reag key changes to

REAG.

Press ESC until you see this screen (three times if you have added reagents);

Press ESC again to reveal the Save Screen; select Yes, the Method is then saved, after which you see the Run Screen.

Dilute Serially				dilution 1
You use Dilute Serially to dilute
samples, with diluent from the
reservoir or via the probe. You	1	4			1
also have the option to mix after			result
dilution, but the addition of
reagents is restricted to Dilute
		2
Normal and Dilute Unknown.
There are 3 modes of entering
the parameters, in each mode		3
you supply Sample Volume
(Vs) plus one of the following
variables:

Dilution Ratio (Rd), Diluent Volume (Vd), and Total Volume (Vt). The software calculates the remaining variables. In any mode, pressing the Data soft-key gives the calculated values for the other two parameters.

dilution 2

71

result

5

6

dilution 3

10

result

8

9

Software

5-19