Gilson 402 manual Operation - Advanced Use, Software, Typical Task Entry

Operation - Advanced Use 5

Software

volume of liquid, is dispensed, at the end of the process, into the waste.

When you configure disposable tips in air mode, ‘Extra volume’ is replaced by ‘Air push volume’ in this task.

1.Aspirate an air gap.

2.Aspirate liquid via the probe.

3.Dispense fractions via the probe.

4.Dispense extra volume to waste.

Typical Task Entry

Key in the File # (e.g. 45), ENTER. Press Edit.

Disp, then press Chge to switch source.

Now, you may select one of two modes, where:

(a)Fractions are equal,

(b)Fractions are different.

Press Chge to change modes, then ENTER, Next.

Key in number of fractions, then ENTER, Next.

For SAME mode, key in ‘Common volume’, for DIFFERENT mode, key in volume for fraction 1.

Press Next, key in volume for fraction 2, Next, etc.

Press ENTER, Next.

Optionally press Extra (only if source is probe), Key in ‘Extra volume’, press ENTER, ESC.

At the last volume screen the Adj key replaces Next. Optionally, press Adj.

Press Chge to switch source, ENTER, then Next. Key in the final volume, ENTER, ESC.

After the data are entered the Adj key is shown as

ADJ.

Optionally at the last of the volume screens, press Flow.

Key in a value for Asp flow, press ENTER. Press Next.

Key in a value for Disp flow, press ENTER.

5-24