Parameter Definition
DECIMAL POINT LOCATION—This selection determines where the decimal point appears in the display.
NONE—No Decimal Place—fixed, no auto-ranging ONE—One Place
TWO—Two Places THREE—Three Places
ATTENTION Auto-ranging will occur for selections of one, two or three decimal places. For example, should the instrument be configured for two decimal places and the PV exceeds 99.99, then the display will change to a single decimal place so that values of 100.0 and above can be shown.
TEMPERATURE UNITS—This selection will affect the indication and operation.
DEG F—Degrees Fahrenheit – Degrees F Annunciator lighted DEG C—Degrees Centigrade – Degrees C Annunciator lighted
NONE—No temperature annunciators lighted. Upper and Lower Displays will show temperature in Degrees Fahrenheit when inputs are configured for Thermocouple or RTD types.
POWER LINE FREQUENCY—Select whether your controller is operating at 50 or 60 Hertz.
ATTENTION For controllers powered by +24 Vdc, this configuration should be set to the AC line frequency used to produce the +24 Vdc supply.
Incorrect setting of this parameter may cause normal mode noise problems in the input readings.
INPUT 2 RATIO—This enables the Ratio for Input 2 to be set from the front panel. Input 2 must be installed and enabled for this configuration to operate.
DISABLE—Disables setting Ratio 2 from front panel.
ENABLE—Allows the Ratio for Input 2 to be set through the keyboard.
LANGUAGE—This selection designates the prompt language.
ENGLISH
FRENCH
GERMAN
SPANISH
ITALIAN
