Changing the default copy-collation setting
You can set the device to automatically collate multiple copies into sets. For example, if you are making two copies of three pages and the automatic collation is on, the pages print in this order: 1,2,3,1,2,3. If automatic collation is off, the pages print in this order: 1,1,2,2,3,3.
To use the automatic collation, the original document must fit into the memory. If it does not, the device makes only one copy and a message appears notifying you of the change. If that happens, use one of the following methods to finish the job:
●Split the job into smaller jobs that contain fewer pages.
●Make only one copy of the document at a time.
●Turn off the automatic collation.
●If using the Best Photo quality setting, try using the Photo setting instead.
The collation setting you select is in effect for all copies until you change the setting.
The collation setting can also be changed from the device software. For instructions about changing settings from the device software, see Changing print settings.
To change the default copy-collation setting
1.On the device control panel, press MENU/ENTER.
2.Use the < or the > button to select Copy setup, and then press MENU/ENTER.
3.Press MENU/ENTER to select Def. Collation.
4.Use the < or the > button to select On or Off.
5.Press MENU/ENTER to save your selection.
Note | The |
52 Chapter 4 Copying | ENWW |
