print jobs sent to the printer either from the server or from a client computer that has set up that printer, includes a reset command at the beginning of the job.

Support Info

Configure links for support assistance. You can designate a support person and the phone number of an administrator for this device, as well as URL addresses for Web-based product and technical support.

Refresh Rate

Time period (in seconds) that the diagnostic pages are automatically updated. A value of zero (0) disables the refresh rate.

Select Language

This item is displayed if the HP Jetdirect Web pages support multiple languages. You can also select supported languages by using the language preference settings in your browser (see your browser's Help).

To display supported non-English languages, you must enable cookies in your browser settings.

Security: Settings

In the SECURITY section, the Settings item provides access to the following tabs: Status (default), Wizard, Restore Defaults. The available settings depend on your particular print server model.

Status

Select the Status tab to display the current security configuration settings of the print server. The settings displayed depend on the features supported by the print server.

Wizard

NOTE: If you use HP Web Jetadmin to manage your devices, do not use this wizard. Instead, use HP Web Jetadmin to configure your network security settings.

Select the Wizard tab to open the initial Wizard page. If prompted with security alerts, click Yes to proceed.

The Wizard page identifies the current security level last configured on the print server. If a security level was not configured, the security level is None. However, if HTTPS is required for access to the networking pages, the default setting indicates Custom.

This page also allows you to run the HP Jetdirect Security Configuration Wizard to set or change the current security level. This wizard guides you through the print server's security configuration settings for your network. Click Start Wizard to run the wizard and open the Security Level page.

The optional configuration parameters presented by the wizard depend on your choice of security level. For an overview, see Table 4-15 Wizard Security Levels on page 91.

NOTE: If you improperly exit the wizard (for example, by failing to use the Cancel button), an Operation Failed screen appears. If this occurs, wait approximately two minutes and restart the wizard.

90 Chapter 4 HP Embedded Web Server (V.45.xx.nn.xx)

ENWW