Table 3-3Telnet Commands and Parameters (continued)

set-cmnty-name

Password to determine which SNMP SetRequests (control functions) the HP Jetdirect

 

print server responds to. The community name of an incoming SNMP SetRequest must

 

match the print server's set community name for the print server to respond. (For

 

additional security, you can limit configuration access through the print server's host

 

access list.) Enter up to 255 alphanumeric characters.

 

 

default-get-cmnty

Default Get community name.

 

0 Disable.

 

1 (default): Enable.

 

Disabling this parameter can prohibit communications with SNMP management

 

applications.

 

 

SNMP Traps

 

 

 

auth-trap

Send SNMP authentication traps. Authentication traps indicate that an SNMP request

 

was received, but the community name check failed.

 

0 Disable.

 

1 (default) Enable.

 

 

trap-dest

Add a host's IP address to the HP Jetdirect print server's SNMP trap destination list. The

 

list can contain up to six entries. To receive SNMP traps, the listed systems must have a

 

trap daemon that listens for the traps. The following is the command format:

 

trap-dest: <ip-address> [community name] [port number]

 

In the example, <ip-address>is the IP address of the host to receive traps,

 

[community name] specifies the SNMP community name, and [port number]

 

identifies the port number to use.

 

The default community name is public. The default SNMP port number is 162. You must

 

enter a community name to specify a port number.

 

To delete the list, set trap destination to zero (trap-dest: 0).

 

By default, the SNMP trap destination list is empty and the print server does not send

 

SNMP traps.

 

 

IPX/SPX

 

 

 

ipx-config

IPX/SPX protocol operation on the print server.

 

0 Disable.

 

1 (default): Enable.

 

NOTE: On HP Jetdirect 640n print servers, all network protocols except TCP/IP are

 

disabled by factory default.

 

 

ipx-unitname

Name assigned to the print server. Enter up to 31 alphanumeric characters. By default,

 

the name is NPIxxxxxx, where xxxxxx are the last six digits of the LAN hardware

 

address.

 

 

Address

(Read-only parameter.) The IPX network and node numbers detected on the network, in

 

the form <network number>:<LAN hardware address>.

 

 

ipx-frametype

IPX frame type settings available for your print server model: AUTO (default), EN_SNAP,

 

EN_8022, EN_8023, EN_II. For more information, see HP Jetdirect configuration

 

pages on page 139.

 

 

ENWW

IPv4 configuration 55