Table 3-3Telnet Commands and Parameters (continued)

roam-threshold

Specify the wireless signal strength level where the print server seeks an access point

 

that provides a stronger signal strength. Select from the following levels:

 

2 (Default): Sets the threshold to a weak signal.

 

1: Sets the threshold to a very weak signal.

 

0: Sets the threshold to where there is no detected signal.

 

When the print server is associated with a particular access point, it remains with that

 

access point until the specified threshold level is reached. Setting the threshold level to

 

0 or 1 can prevent or limit the print server from roaming.

 

 

802.11 Wireless Diagnostics

 

 

 

Current SSID

(Read-only parameter) The network name (SSID) to which the wireless print server is

 

connected.

 

 

Current Channel

(Read-only parameter) The channel that the wireless print server is currently using.

 

 

Signal Strength

(Read-only parameter) Strength of the radio signal received by the print server.

 

<blank>: No radio signal detected while the print server is scanning.

 

No Signal: No radio signal detected on any channel.

 

Poor/Marginal/Good/Excellent: Detected signal strength level.

 

 

Access Point Mac

(Read-only parameter) The media access control (MAC) address of the access point

 

used for Infrastructure mode communications, as in the following example:

 

00:a0:f8:38:7a:f7

 

In this example, the access point with MAC address 00a0f8387af7 is used for

 

communicating on the network.

 

 

TCP/IP Main

 

 

 

llmnr

Link local multicast name resolution (LLMNR).

 

0: Disable.

 

1 (defualt): Enable.

 

 

host-name

Name of the network device. Enter up to 32 alphanumeric characters.

 

For example, host-name printer1 assigns the name printer1 to the device. The

 

default host name is NPIxxxxxx, where xxxxxx are the last six digits of the LAN

 

hardware (MAC) address.

 

 

ip-config

Print server configuration method. Use the following values:

 

manual: Wait for IP parameters using manual tools, such as Telnet, the HP Embedded

 

Web Server, the control panel, or installation/management software. Status is User

 

Specified.

 

bootp: Send BOOTP requests on the network for dynamic IP configuration.

 

dhcp: Send DHCP requests on the network for dynamic IP configuration.

 

auto_ip: Automatically configure with a unique link-local address 169.254.x.x.

 

 

46 Chapter 3 TCP/IP configuration

ENWW