Table 3-2TFTP configuration file parameters (continued)

default-ip:

IP address to use when the print server is unable to obtain an IP address from the network during a forced TCP/IP re- configuration. For example, when turned off and then on or when manually configured to use BOOTP/DHCP.

DEFAULT_IP: Set the legacy default IP address 192.0.0.192.

AUTO_IP: Set a link-local IP address 169.254.x.x.

The initial setting is determined by the IP address obtained when first turned on.

default-ip-dhcp:

Periodically transmit DHCP requests when a legacy default IP address 192.0.0.192 or link-local IP address 169.254.x.x is automatically assigned.

0: Disable.

1 (default): Enable DHCP requests.

dhcp-arbitration:

Seconds that the print server waits for DHCP configuration offers. The range is between 1 and 10 seconds. 0: Disable.

5 (default): Enable.

web-refresh:

Time interval for HP Embedded Web Server diagnostic page updates. The range is between 1 and 99999 seconds. 0: Disable.

SNMP

snmp-config:

SNMP operation on the print server. 0: Disable. 1 (default): Enable SNMP operation.

CAUTION: Disabling SNMP disables all SNMP agents (SNMP v1, v2, v3), communication with HP Web Jetadmin, and firmware upgrades using HP downloading utilities.

get-cmnty-name: (or get-community-name:)

Optional. Password to determine which SNMP GetRequests the HP Jetdirect print server responds to. If a Get community name is set, the print server responds to either a user-specified community name or the factory-default. Enter up to 255 alphanumeric characters.

set-cmnty-name: (or set-community-name:)

Password to determine which SNMP SetRequests (control functions) the HP Jetdirect print server responds to. The community name of an incoming SNMP SetRequest must match the print server's Set community name for the print server to respond. (For additional security, you can limit configuration access through the print server's host access list.) Enter up to 255 alphanumeric characters.

auth-trap: (or authentication-trap:)

Send SNMP authentication traps. Authentication traps indicate that an SNMP request was received, but the community name check failed. 0: Disable. 1 (default): Enable.

ENWW

IPv4 configuration 33