Table 4-9TCP/IP Advanced tab (continued)

Item

Description

 

 

Syslog Server

(IPv4 only) IP address of a host computer that is configured to receive syslog

 

messages from the HP Jetdirect print server. If a syslog server is not specified, syslog

 

messages are disabled.

 

 

Syslog Protocol

(IPv4 only) Select whether to transport syslog messages to the syslog server using

 

the TCP or UDP protocol.

 

 

Syslog Port

(IPv4 only) Valid port number to use for transporting syslog messages to the syslog

 

server using the TCP or UDP protocol.

 

 

Syslog Maximum Messages

(IPv4 only) Maximum number of syslog messages sent by the HP Jetdirect print

 

server per minute. Allows you to control the log file size. The default is 10 per minute.

 

If set to zero, no maximum number is defined.

 

 

Syslog Priority

(IPv4 only) Filter syslog messages sent to the syslog server. Enter from 0 to 7, with 0

 

being the most specific and 7 being the most general. Only messages that are lower

 

than the specified filter level (that is, higher in priority) are reported. The default value

 

7 reports all syslog messages. A value of 8 disables syslog reporting.

 

 

Enable CCC Logging

Select or clear the check box to enable (default) or disable HP customer care logging.

 

 

Network Settings

Use the Network Settings pages to set or change configuration parameters for IPX/SPX

on page 81, AppleTalk on page 82, DLC/LLC on page 83, and SNMP on page 83 protocols. To assign a parameter setting, enter the desired value and click Apply.

NOTE: The features displayed depend on the print server. Value-featured print servers provide limited protocol support.

IPX/SPX

Use the IPX/SPX tab to configure IPX/SPX parameters on the HP Jetdirect print server. IPX/SPX protocols are used for operation on a Novell NetWare or compatible IPX/SPX network (such as a Microsoft network). For a description of the items, see Table 4-10IPX/SPX tab settings on page 81.

CAUTION: If you are using direct-mode printing over IPX/SPX on a Microsoft network, do not disable IPX/SPX.

For a Novell NetWare network:

●Use the HP Embedded Web Server to select Queue Server Mode parameters in a Novell Directory Services (NDS) environment.

●Do not use the HP Embedded Web Server to create the NDS print server, printer, and queue objects. Instead, use another tool or utility.

Table 4-10IPX/SPX tab settings

ItemDescription

IPX/SPX Enable

Select the check box to use IPX/SPX protocols.

 

 

ENWW

Networking tab 81