Table C-1HP Jetdirect EIO Menu on Graphical Control Panel (continued)

Menu item

Sub-menu item

Sub-menu item

Values and Description

 

 

 

 

Link Speed

 

 

Set the print server's link speed. The available

 

 

 

settings depend on the device and installed print

 

 

 

server. Select one of the following modes:

 

 

 

Auto (default): Use auto-negotiation to configure the

 

 

 

highest link speed and communication mode allowed.

 

 

 

If auto-negotiation fails, either 100TX HALF or 10TX

 

 

 

HALF is set depending on the detected link speed of

 

 

 

the hub/switch port. (A 1000T half-duplex selection is

 

 

 

not supported.)

 

 

 

10T Half: 10 Mbps, half-duplex operation.

 

 

 

10T Full: 10 Mbps, full-duplex operation.

 

 

 

100TX Half: 100 Mbps, half-duplex operation.

 

 

 

100TX Full: 100 Mbps, full-duplex operation.

 

 

 

100TX Auto: Limits auto-negotiation to a maximum

 

 

 

link speed of 100 Mbps on 1000T networks.

 

 

 

1000TX Full: 1000 Mbps, full-duplex operation.

 

 

 

CAUTION: Changing the link setting can cause the

 

 

 

loss of network communication with the print server.

 

 

 

 

Print Protocols

 

 

Print a page that lists the configuration of the following

 

 

 

protocols: IPX/SPX, Novell NetWare, AppleTalk, DLC/

 

 

 

LLC.

 

 

 

 

188 Appendix C HP Jetdirect control panel menus (V.45.xx.nn.xx)

ENWW