Table
Message | Description |
|
|
STATUS | Current state of the HP Jetdirect print server. |
| I/O CARD READY, or READY Successfully connected to the network and is awaiting |
| data. |
| I/O CARD INITIALIZING, or INITIALIZING Initializing the network protocols. For more |
| information, see the status line for each protocol on the configuration page. |
| I/O CARD NOT READY, or ERROR Problem detected with the print server or its |
| configuration. |
| An error code and message is displayed if the print server is not ready. For more |
| information, see Table |
|
|
DATA RATE DETECTED | Specifies the network data rate depending on the type of network connection: |
| |
| 10 Mbs, 100 Mbps, 1000 Mbps (Wired Ethernet) |
|
|
MODEL NUMBER | Product number of the HP Jetdirect print server (for example, J7961G) |
|
|
LINK CONFIG | Specifies the active link communication mode: |
| 802.11: Wireless 802.11bgn |
| 10T HALF: 10 Mbps, |
| 10T FULL: 10 Mbps, |
| 100TX HALF: 100Mbps, |
| 100TX FULL: 100Mbps, |
|
|
HARDWARE ADDRESS | The |
| server installed in the printer or device. This address is assigned by the manufacturer. |
|
|
PORT SELECT | (Ethernet only) Specifies the port detected for use on the HP Jetdirect print server: |
| NONE: The print server is not connected to the network. |
| |
|
|
FIRMWARE VERSION | Firmware revision number of the HP Jetdirect print server currently installed in the |
| printer. |
|
|
LAA | Locally administered address (LAA) identifies the specified LAN hardware address of |
| a print server, which is required by some network adiministrators. The default address |
| is the print server's |
|
|
MANUFACTURING ID | Manufacturing identification code for use by HP online support personnel. |
|
|
S/N | HP Jetdirect serial number. |
|
|
DATE MANUFACTURED | Manufacture date of the HP Jetdirect print server. |
|
|
802.11 Wireless station settings
Wireless station status, configuration parameters and error messages are listed in Table
142 Chapter 8 HP Jetdirect configuration pages | ENWW |