Table 3-2TFTP configuration file parameters (continued)

AppleTalk

appletalk: (or at-config:,ethertalk:)

Use AppleTalk (EtherTalk) protocol operation on the print server. 0: Disable. 1 (default): Enable.

NOTE: On HP Jetdirect 640n print servers, all network protocols except TCP/IP are disabled by factory default.

DLC/LLC

dlc/llc-config: (or dlc/llc:)

Use DLC/LLC protocol operation on the print server. 0: Disable. 1 (default): Enable.

NOTE: On HP Jetdirect 640n print servers, all network protocols except TCP/IP are disabled by factory default.

Other Settings

link-type:

(For wired 10/100/1000T Ethernet.) Set the print server's link speed (10, 100, 1000 Mbps) and communication mode (Full- or Half-Duplex). The available link-speed depends on the print server model. The communication modes are: AUTO, 1000FULL, 100AUTO, 100FULL, 100HALF, 10FULL, 10HALF.

For AUTO (default), the print server uses auto-negotiation to configure the highest link speed and communication mode allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set, depending on the detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.)

upgrade:

Set the name and location of a firmware upgrade file for the HP Jetdirect print servers.

CAUTION: Ensure that command parameters are properly entered. Verify that the upgrade file is a higher version than the currently installed version. The print server attempts to upgrade when the upgrade file contains a higher version than the installed version.

The following is the command format:

upgrade: <TFTP server IP> <Version> <Product Number> <Filename>

The following defines the parameters:

<TFTP Server IP> IP address of the TFTP server.

<Version> Firmware version of the upgrade file.

<Product Number> Print server product number.

<Filename> Path and filename of the firmware upgrade file.

hw-acclrn-conf

Use hardware acceleration. 0: Disable. 1 (default): Enable.

status-page-lang:

Page description language (PDL) that the print server uses to send the HP Jetdirect configuration/status page to the printer.

◦Auto (default): Auto-detected when the print server is turned on or after a cold reset.

◦PCL: Hewlett-Packard Printer Control Language.

◦ASCII: Standard ascii characters.

ENWW

IPv4 configuration 35