To set configuration parameters, you must set up a Telnet session from your system to the HP Jetdirect print server.
1.At the system prompt, type the following: telnet <IP address>
The <IP address> is the IP address listed on the HP Jetdirect configuration page. See HP Jetdirect configuration pages on page 139.
2.A connection to the HP Jetdirect print server is displayed. If the server responds with connected to IP address, press Enter twice to initialize the Telnet connection.
3.Type the user name and password, if required.
By default, the Telnet interface does not require a user name or password. If an administrator password is set, enter the user name and password. Otherwise, you cannot enter or save Telnet settings.
4.By default, a command line interface is provided. To set parameters using a menu interface, enter Menu. For more information, see Telnet user interface options on page 41.
For a list of supported commands and parameters, see Table
Telnet user interface options
The HP Jetdirect print server provides two interface options to enter Telnet commands: a Telnet command line interface (default) on page 41 and a Menu Interface on page 59.
Telnet command line interface (default)
Using the Telnet command line interface, you can set configuration parameters using the following procedures:
ENWW | IPv4 configuration 41 |