Enter up to ten rules, each rule specifying the host addresses, services, and the action to take for those addresses and services. Depending on whether IPsec is supported by the print server and device, the following actions are available:

●Allow traffic. If IPsec/Firewall is supported, allow IP traffic that is not protected by the IPsec/ Firewall policy.

●Drop traffic. Do not process (discard) the specified IP traffic.

●Require traffic to be protected with the IPsec/Firewall policy. You are prompted to configure an IPsec template indicating the IPsec authentication/encryption settings to apply to the specified IP traffic.

See the following illustration.

Figure 5-3Use the IPsec Wizard to configure rules

HP Jetdirect

IPsec/Firewall Policy

IPsec/Firewall Rules

...

Use the IPsec/Firewall Wizard

to Configure Each Rule

 

Rule 1

 

{

 

 

 

 

 

Step 1, select:

Step 2, select:

Step 3, select:

 

Allow, Drop, or

 

 

 

Addresses1

Services1

 

 

 

Protect with IPsec1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Step 1, select:

Step 2, select:

Step 3, select:

 

Rule 2

Allow, Drop, or

 

Addresses2

Services2

 

Protect with IPsec2

 

 

 

 

 

 

 

...

 

 

 

 

 

 

Limitations to rules, templates and services

Limitations to rules, templates, and services are summarized in the following table.

Table 5-2Limitations to rules, templates and services

Item

Limit

 

 

Maximum number of rules.

10

 

 

Maximum number of Address Templates.

8

Note the following:

 

●All IP Addresses Results in two (2) address template rules. One for all IPv4 addresses, and another for all IPv6 addresses.

●All non link local IPv6 Results in four (4) address template rules:

◦:: to FE7F:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF for both local and remote addresses

◦:: to FE7F:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF for local addresses

FE81:: to FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF for remote addresses

ENWW

HP Jetdirect IPsec/Firewall wizard 109