Table 3-3Telnet Commands and Parameters (continued)

ipsec-config

NOTE: The ipsec-configcommand is available on print servers that support both

firewall-config

IPsec and Firewall configuration. The firewall-configcommand is available on full-

featured print servers that do not support IPsec, but allow Firewall configuration.

 

Disable IPsec or Firewall operation on the print server after IPsec/Firewall policies are

 

configured and enabled. You cannot enable IPsec/Firewall operation using this

 

command. Instead, use the HP Embedded Web Server to configure and enable IPsec/

 

Firewall polices.

 

0: Disable IPsec/Firewall operation.

 

1: (Read Only) IPsec/Firewall policies are configured and enabled.

 

 

ip

IP address for the print server. For example:

 

ip-config manual

 

ip 192.168.45.39

 

In the example, manual signifies manual configuration and ip sets the IP address on

 

the print server.

 

To clear the IP address, set the value to 0.0.0.0.

 

If you change this IP address, you must use it on the next Telnet connection.

 

 

subnet-mask

Identify the network and host portions of an IPv4 address in received messages. For

 

example:

 

subnet-mask 255.255.255.0

 

In the example, 255.255.255.0 is stored on the print server. To clear the subnet IP

 

address and disable the mask, set the value to 0.0.0.0.

 

NOTE: If the HP Jetdirect print server is configured by DHCP and you manually

 

change the subnet mask or the default gateway address, you should also change the

 

print server's IP address. This releases the assigned DHCP address back to the DHCP

 

IP address pool.

 

 

default-gw

IP address of a default gateway used by the print server. For example:

 

default-gw 192.168.40.1

 

In the example, 192.168.40.1 is the IP address of the default gateway.

 

NOTE: If the HP Jetdirect print server is configured by DHCP and you manually

 

change the subnet mask or the default gateway address, you should also change the

 

print server's IP address. This releases the assigned DHCP address back to the DHCP

 

IP address pool.

 

 

parm-file

Path and file name whose contents are printed each time the print server is turned on.

 

Enter up to 64 alphanumeric characters.

 

 

Config Server

(Read only.) IP address of the server (such as a BOOTP or DHCP server) that last

 

configured the IP address on the HP Jetdirect print server.

 

 

TFTP Server

(Read only.) IP address of the TFTP server that provided parameters to the HP Jetdirect

 

print server.

 

 

TFTP Filename

(Read only.) Path and TFTP filename on the TFTP server. For example:

 

hpnp/printer1.cfg

 

 

ENWW

IPv4 configuration 47