Table
Error Code and Message | Description | |
|
|
|
51 | TFTP RETRIES EXCEEDED | Retry limit exceeded when transferring the TFTP configuration file from the host to |
|
| the HP Jetdirect print server. |
|
|
|
52 | BAD BOOTP/DHCP REPLY | Error detected in the BOOTP or DHCP reply received by the HP Jetdirect print server. |
|
| The reply contains insufficient data in the UDP datagram for the minimum BOOTP/ |
|
| DHCP header of 236 bytes, has an operation field that is not BOOTPREPLY(0X02), |
|
| has a header field that does not match the print servers hardware address, or |
|
| contains a UDP source port that is not the BOOTP/DHCP server port (67/udp). |
|
|
|
53 | BAD BOOTP TAG SIZE | Tag size in a |
|
| remaining number of unprocessed bytes in the |
|
|
|
54 | BOOTP/RARP IN PROGRESS | Print server is obtaining its basic IP configuration information through BOOTP/RARP. |
|
|
|
55 | BOOTP/DHCP IN PROGRESS | HP Jetdirect print server is obtaining its basic IP configuration information through |
|
| BOOTP/DHCP (no errors detected). |
|
|
|
56 | DHCP NAK | Print server received a negative acknowledgement message from the DHCP server in |
|
| response to a configuration request. |
|
|
|
57 | UNABLE TO CONNECT DHCP | The HP Jetdirect print server received IP parameters from a DHCP server, but |
SVR | communication with the server is lost. Check status of the DHCP server. | |
|
| If an infinite lease is assigned, the print server uses the IP address of the most recent |
|
| DHCP server. Operation can degrade until a DHCP server responds. |
|
|
|
58 | POSTSCRIPT MODE NOT | Printer does not support AppleTalk or AppleTalk extensions. |
SELECTED |
| |
|
|
|
59 | INCOMPLETE F/W - MUST | Currently downloading firmware to the HP Jetdirect print server, or the download did |
DOWNLOAD | not complete properly. | |
|
| |
5A TURN PRINTER OFF / ON | Firmware download is complete. Turn the HP Jetdirect print server off and then on. | |
|
| |
5C DHCP BAD REPLY | Bad reply received from the DHCP server. Check your DHCP server settings for this | |
|
| print server. |
|
| |
5D DHCP LEASE DURATION TOO | DHCP lease times for this print server's TCP/IP configuration settings are too short. | |
SHORT | ||
|
| |
5E DHCP LEASE RELEASED | Lease parameters for DHCP, including the IP address, were released through a | |
|
| manual configuration method, such as the printer's control panel. |
|
| |
5F WINS REGISTRATION FAILED | Cannot register the print server's name on the WINS server. Check for duplicate | |
|
| names, or verify the WINS server configuration. |
|
|
|
61 | AUTO IP CONFIGURED | Cannot retrieve an IP address over the network. The print server defaults to an IP |
|
| address using |
|
|
|
62 | DEFAULT IP CONFIGURED | Cannot retrieve an IP address over the network. The print server defaults to a legacy |
|
| IP address 192.0.0.192. |
|
|
|
63 | AUTO IP IN PROGRESS | The print server is automatically assigning an IP address using |
|
| in the form 169.254.x.x. |
|
|
|
64 | INVALID PASSWORD | An invalid password was specified through TFTP. Verify that the password consists of |
|
| a maximum of 16 printable characters. |
|
|
|
65 | DOWNLOAD NOT ALLOWED | This print server does not allow firmware upgrade over a wireless network |
ON WIRELESS | connection. | |
|
|
|
83 | DISCONNECTING FROM | Server shut down because of a configuration change or reset request. This message |
SERVER | automatically clears after a few seconds, unless the printer is offline, is in an error | |
|
| state, or is servicing another I/O port or another network protocol. |
|
|
|
158 Chapter 8 HP Jetdirect configuration pages | ENWW |