Table
Message | Description |
|
|
DHCPV6 | IPv6 stateful address configured by a DHCPv6 server. |
| Not Configured Address is not set. |
|
|
MANUAL | IPv6 address manually configured on the print server, using the printer control panel |
| or the HP Embedded Web Server. |
| Not Configured Address is not set. |
|
|
IPX/SPX protocol information
Information in this section of the HP Jetdirect configuration page is described in Table
Table
Message | Description |
|
|
STATUS | Current IPX/SPX protocol status. |
| READY Print server is awaiting data. |
| DISABLED Manually disabled. |
| INITIALIZING Registering the node address or name. An additional status message |
| might also displayed. |
| An error code and message is displayed if the print server is not ready. For more |
| information, see Table |
|
|
PRIMARY FRAME TYPE | Frame type selection. |
| AUTO SELECT Automatically sense and limit to the first one detected. |
| EN_8023 Limit to IPX over IEEE 802.3 frames. All others are counted and discarded. |
| EN_II Limit to IPX over Ethernet frames. All others are counted and discarded. |
| EN_8022 Limit to IPX over IEEE 802.2 with IEEE 802.3 frames. All others are |
| counted and discarded. |
| EN_SNAP Limit to IPX over SNAP with IEEE 802.3 frames. All others are counted |
| and discarded. |
|
|
NETWORK | Network column specifies the network number associated with a protocol frame type |
FRAME TYPE | used for communication between a server and the HP Jetdirect print server. |
UNKNOWN Determining which network number to use. | |
RCVD | Frame Type column identifies the frame type used with the associated network |
| number: EN_8023, EN_8022, EN_II, EN_SNAP. Unless a specific frame type is |
| manually set, the print server automatically determines the protocol frame type by |
| listening to the network data. DISABLED Frame type for that network is manually |
| configured. |
| RCVD column displays the packets received for each frame type. |
|
|
150 Chapter 8 HP Jetdirect configuration pages | ENWW |