Using the arp and ping commands with HP Jetdirect print servers requires the following:
●Microsoft Windows XP, Windows Server 2003, Windows Server 2008, or UNIX system configured for TCP/IP operation
●Legacy default IP address of 192.0.0.192 on the print server
●LAN hardware (MAC) address of the HP Jetdirect print server, specified on an HP Jetdirect configuration page, or on a label attached to HP Jetdirect external print servers
NOTE: You might need root privileges to run the arp command.
After an IP address is assigned using the arp and ping commands, use other tools such as Telnet, the HP Embedded Web Server, or HP Web Jetadmin to configure other IP parameters.
To configure an HP Jetdirect print server, use the following commands:
arp
ping <IP address>
The <IP address> is the desired IP address assigned to the print server, and <LAN hardware address> is the LAN hardware address of the print server. The arp command writes the entries to the arp cache on the workstation. The ping command configures the IP address on the print server.
The LAN hardware address can require a specific format, as in the following examples:
●Microsoft Windows XP, Windows Server 2003, or Windows Server 2008
arp |
ping 192.168.45.39
●For UNIX
arp | 00:01:E6:a2:31:98 |
ping 192.168.45.39
NOTE: Once the IP address is set on the print server, additional arp and ping commands are ignored. To again use arp and ping to configure the IP address, reset the print server to factory values. See Troubleshoot the HP Jetdirect print server on page 125.
On UNIX systems, the arp
Some BSD systems expect the IP address (or host name) in reverse order. Other systems require additional parameters. See your system documentation for specific command formats.
If you are configuring an HP Jetdirect wireless print server, this section assumes that a wireless network connection is established.
Use Telnet (IPv4)This section describes how to configure the print server using Telnet.
ENWW | IPv4 configuration 39 |