Table 3-3Telnet Commands and Parameters (continued)

1000t-ms-conf

Configure the print server as a master or slave device on a 1000T network.

 

AUTO or 0 (default): Master/slave configuration is automatically sensed and assigned.

 

MASTER or 1: Configure as a 1000T master device.

 

SLAVE or 2: Configure as a 1000T slave device.

 

 

1000t-pause-conf

Control the flow of inbound and outbound data.

 

OFF or 0 (default): Disable flow control.

 

AUTO or 1: Configure through auto-negotiation with the network switch.

 

RCV or 2: Enable only for data received from the network.

 

TRANS or 3: Enable only for data transmitted to the network.

 

TXRX or 4: Enable for both received and transmitted data.

 

 

network-select

(For HP Jetdirect products with a dual wired/wireless port. Specifies the active behavior

 

of the print server.)

 

● Auto (default): Automatically detects whether a network cable is attached. If a

 

network cable is not attached, only the IEEE 802.11bgn wireless port is active. If a

 

network cable is attached, then only the IEEE 802.3 wired port is active.

 

CAUTION: Do not plug a network cable into an active wired/wireless port if the

 

network-select command is set to Auto. Wireless access will immediately

 

terminate.

 

● Wired: Only the 802.3 wired port is active.

 

● Wireless: Only the 802.11bgn wireless port is active.

 

 

link-type

(For wired 10/100/1000T Ethernet.) Set the print server's link speed (10, 100, 1000

 

Mbps) and communication mode (Full- or Half-Duplex). The available link-speed

 

depends on the print server model. Select from the following communication modes:

 

AUTO (default): Use auto-negotiation to configure the highest link speed and

 

communication mode allowed.

 

1000FULL: 1000 Mbps, full-duplex operation.

 

100AUTO: Limit auto-negotiation to a maximum link speed of 100 Mbps.

 

100FULL: 100 Mbps, full-duplex operation.

 

100HALF: 100 Mbps, half-duplex operation.

 

10FULL: 10 Mbps, Full-duplex operation.

 

10HALF: 10 Mbps, half-duplex operation.

 

 

hw-acclrn-conf

Use hardware acceleration.

 

0: Disable.

 

1 (default): Enable.

 

 

58 Chapter 3 TCP/IP configuration

ENWW