Table 3-3Telnet Commands and Parameters (continued)

Status

(Read-only parameter.) Current AppleTalk configuration status.

 

READY: HP Jetdirect print server is awaiting data.

 

DISABLED: AppleTalk was manually disabled.

 

INITIALIZING: Print server is registering the node address or name. An additional

 

status message might also be displayed.

 

 

DLC/LLC

 

 

 

dlc/llc-config

Use DLC/LLC protocol operation on the print server (if supported).

 

0: Disable.

 

1 (default): Enable.

 

NOTE: On HP Jetdirect 640n print servers, all network protocols except TCP/IP are

 

disabled by factory default.

 

 

strict-8022

Controls DLC/LLC protocol interpretation:

 

0 (default): Disable. Provide loose interpretation.

 

1: Enable. Provide strict interpretation.

 

 

Other

 

 

 

upgrade

Set the name and location of the firmware upgrade file for the HP Jetdirect print servers.

 

CAUTION: Ensure that command parameters are properly entered and that the

 

upgrade file is a higher version than the currently installed version. The print server

 

attempts to upgrade if the upgrade file contains a higher version than the installed

 

version.

 

The following is the command format:

 

upgrade: <TFTP server IP> <Version> <Product Number> <Filename>

 

The following defines the parameters:

 

<TFTP Server IP> IP address of the TFTP server, <Version> firmware version of

 

the upgrade file, <Product Number> print server product number <Filename> path

 

and filename of the firmware upgrade file.

 

 

laa

Specify a locally administered address (LAA) to replace the factory-assigned LAN

 

hardware (MAC) address. If LAA is used, enter a string of exactly 12 hexadecimal digits.

 

For Ethernet print servers, the LAA must start with hexadecimal X2, X6, XA, or XE,

 

where X is any hexadecimal digit 0 through F.

 

The default address is the factory-assigned address.

 

 

xml-services-conf

Allow access by HP Web service applications to XML-based data on the HP Jetdirect

 

print server.

 

0: Disable.

 

1 (default): Enable.

 

 

ws-discovery-conf

Allow Microsoft WS discovery protocols on the print server.

 

1 (default): Enable.

 

0: Disable.

 

 

ENWW

IPv4 configuration 57