HP General IO Connectivity Configuring PAD Services, Add/Modify PAD Terminal Emulation Local to

Configuration

Configuring PAD Services

Configuring PAD Services

This section contains step-by-step instructions for configuring PAD services. Skip this section if you don’t need to configure PAD services.

The procedures in this section are optional. Your X.25 link software does not require you to configure PAD services.

You can use SAM to add or modify the following:

• PAD terminal emulation (local to remote)

• PAD support server (remote to local)

• PAD printer server

• PAD UUCP server

• X.3 sets of parameters

See Chapter 6, PAD Services, for detailed reference information on PAD services.

This section assumes that SAM is running and that you are starting from the main window. If this is not the case, type sam at the HP-UX prompt before continuing.

Remember to use the Help button (in the SAM window) to display information and instructions for the content of each field.

		Add/Modify PAD Terminal Emulation (Local to
		Remote)
		Follow the steps below to add or modify PAD terminal emulation for a
		remote system:
Step	1.	At the SAM main window, highlight “Networking and Communications”
		and select Open Item from the Actions menu.
Step	2.	At the “Networking and Communications” window, highlight X.25 PAD
		Services and select Open Item from the Actions menu.
Step	3.	Highlight Terminal Emulator and select Open Item from the Actions
		menu.

74 Chapter 3