Configuration
Configuring Remote System Access
|
| Configuring Remote System Access |
|
| Follow the steps below to configure access to other hosts and systems |
|
| that use TCP/IP protocol. (The procedures in this section are optional. |
|
| Your X.25 link software does not require that you configure access to |
|
| other systems). |
Step | 1. | If you have not already done so, type sam at the |
Step | 2. | At the SAM main window, highlight Networking and Communications |
|
| and click on OPEN. |
Step | 3. | At the “Networking and Communications” window, highlight Hosts and |
|
| click on OPEN. Highlight Local Hosts and click on OPEN. |
|
| SAM displays all remote system names and IP addresses that have |
|
| already been configured. |
Step | 4. | Select Add from the Actions menu. The following dialog appears: |
|
|
|
NOTE |
| The appearance of the “Add Internet Connectivity” dialog may be slightly |
|
| different from the example below depending on the version of the X.25 |
|
| software you are running. |
|
|
|
Chapter 3 | 51 |
