|
|
| Configuration |
|
|
| Configuring X.25 over LLC2 |
neg_inthruputclass 19200 | # offered thruput class if using thruput class | ||
negotiation |
|
|
|
neg_outthruputclass 19200 | # offered thruput class if using thruput class | ||
negotiation |
|
|
|
pvc_inpacketsize 128 | # packetsize for PVCs | ||
pvc_outpacketsize 128 | # packetsize for PVCs | ||
pvc_inwindow 7 |
|
| # window size for PVCs |
pvc_outwindow 7 |
|
| # window size for PVCs |
# IP Related Parameters |
| ||
IP 15.4.64.120 |
| 255.255.248.0 # IP address and subnet mask | |
mtu 1024 |
|
| # max transmission unit 1024 octets |
hold 300 |
|
| # 5 minute hold timer |
idle 600 |
|
| # 10 minute idle timer |
|
|
| |
NOTE |
| For an XOL configuration, L3 packet sizes greater than 1024 are not | |
|
| supported. |
|
|
| If the XOL interface on the host is connected to a router supporting X.25 | |
|
| ||
|
| over LLC2, the router must be configured with the correct routing | |
|
| entries. For example, if an XOL interface on the host is connected to a | |
|
| CISCO router and the XOL configuration on the host is identical to the | |
|
| configuration in the previous example, the following configuration is | |
|
| required: |
|
|
| • To enable the cmns, complete the following steps: | |
Step | 1. | Run the following command at the CISCO console: | |
|
| Configure Terminal | |
Step | 2. | Run the following command at the CISCO console: | |
|
| Interface fastethernet 1/0 | |
Step | 3. | Run the following command at the CISCO console: | |
|
| cmns enable |
|
Step | 4. | Run the following command at the CISCO console: | |
Chapter 3 | 63 |
