PAD Services
PAD Commands
PAD Commands
PAD command signals are grouped into the X.28 PAD command set (defined by CCITT X.28 recommendations) and include an extended command set providing additional functionality.
X.28 PAD Command Set
clr
Clears a virtual circuit (VC), disconnecting the VC from the remote host.
int
Transmits an interrupt to the remote host.
par?
Displays all of the X.3 parameters and their current values. The format for the display is:
X.3 parameter number: current value
prof [profile_id]
Interprets a prepared set of command signals from a profile. Profiles must be placed in the file /etc/x25/x3config.
reset
Resets a virtual circuit (VC). When a VC is reset, all data received (but unread) is lost, and all X.3 parameters are set to the default values (as they were defined before the VC was established).
set n:v [,n:v]
Sets the X.3 parameter n to value v. If there is a syntax error, padem responds with an ERR service signal and updates the diagnostic text. All changes take effect when a new VC is established, or immediately if one is already established.
set? n:v [,n:v]
164 | Chapter 6 |
